FP-XA Flex-Coupled End Suction

The FP-XA flex-coupled end suction product line is one of the most economical fire production products available today.  This product can be electric or diesel engine driven and is available in many flows and pressures in both 50 & 60 cycle speeds.  The centerline discharge means that an air relief valve is not required, making this a more economical choice over other manufacturers tangential end suction designs.  Packing and grease lubrication round out the list of standard features that appear in our fire pump product line.  The performance is based off of our proven XA product line.
FP-XA Flex-Coupled End Suction

Flow & Pressure Characteristics

Flows To:  50 GPM To 1,500 GPM (11 m³/hr To 341 m³/hr)
Heads To:  210 PSI (14.5 bar)
Speed Ranges:  1500 RPM To 3600 RPM

Size Range

1.25×2-8 (32/20) – 6×8-16 (150/40)

Features & Benefits

  • Cast iron casing/investment cast 304 stainless steel impeller
  • Back pump out vanes or rear wear ring standard for hydraulic balancing
  • Back pull out rotor assembly design
  • Standard bronze, renewable case wear ring
  • Internal plan 1 seal/packing flush
  • Packing & lantern ring standard
  • Francis, enclosed, high efficiency impeller with broad band operating range
  • 125# suction/125# discharge flange with 250# cast dimensions standard
  • Drilled & tapped suction & discharge flanges for easy connection to system piping
  • Suction & discharge gauge connections standard
  • 50,000+ hour minimum L10 bearing standard
  • Turned, ground and polished 420 stainless steel shaft standard
  • Grease lubricated power frame
  • Dual oil lip seal construction
  • Electric or Diesel engine driven

Available Metallurgies

  • Cast iron, 304 stainless steel fitted, all 316 stainless steel fitted

Markets

  • Fire Protection

Documentation

PRODUCT BROCHURE

IOM MANUAL